how to assemble a computer
How to Assemble a Computer
Are you of the opinion, that if you knew how to assemble a computer, you would save a lot of money, instead of buying a computer from the market? This article includes tips for assembling a PC on your own.
- The first step is to install the power supply into the case, if it has come as separate components. Ensure that you secure the power supply using the four screws provided.
- We will now see the procedure to install a new motherboard, for which, you will have to open the motherboard and line it up to the expansion slots located at the back of the case.
- Place the standoffs into the motherboard case at any point, where a screw hole in the motherboard lines up with the standoff slot in the case.
- Now is the time to secure the motherboard with screws and connect it properly to the right lead from the power supply.
- The panel lights and switches on the case to the motherboard should be connected now. If you have any front panel USB or sound headers, connect them now.
- Place the processor such that the marked corners on the processor and socket, line up correctly. Gently place the processor into place, and lock it with the lever on the side of the socket. Be careful, when you do this step.
- We will now install the heat sink and fan assembly over the processor, so that the processor does not heat up. Make sure you have thermal grease in between the heat sink and fan assembly.
- After you are done with installing the heat sink and fan assembly, immediately hook the power lead from the fan to the motherboard.
- In this step, we will see how to install a RAM. Check, which is the right socket for the RAM and then gently place it into the sockets until it clicks.
- After the processor and computer memory, hard drive is the next to be installed. Place the hard drive into the case and connect the IDE or SATA cables to the motherboard.
- If you want to have a CD-ROM drive for your machine, now is the time to install it as well. Place the drive in the appropriate slot in the case.
- Now, connect a cable from the power supply to both the hard drive and the CD-ROM drive.
- After the drives have been installed, the sound card, video card, and network card are to be installed, into the PCI, AGP, or PCI Express slots. Connect the appropriate cables along with these cards.
- We are now done with installing all the internal components, now is the time to connect all external components, like the keyboard, mouse and monitor.
- After all the hardware components, we need to install the required software. The basic being the operating system, for which you will have to boot the system and install an operating system of your choice.